Kalėdos
Užsakyti prieš 16.12.  -  Daugiau informacijos
×
Menu

Alpinist U-Bow

(10)
1 pora
Kiekis.
1 pora
2 poros
3 poros
4 poros
Limited quantity available
Kiekis.
1 pora
2 poros
3 poros
4 poros
5 poros
6 poros
7 poros
8 poros
9 poros
10+
Į krepšelį
  Išsaugoti vėlesniam laikui
Nemokamas pristatymas iš €79
Pristatymas 4-5 darbo dienos
365 dienų grąžinimo politika

Aprašymas

"Marker Alpinist U-Bow" aksesuaras, skirtas "Alpinist pin tech" surišimui.

Šią kulno dalį galite rinktis iš skirtingų standumo variantų.

  • Minkšta = maždaug 5,5DIN
  • Vidutinė = apie 8DIN
  • Tvirtas = apie 11DIN

Modelio specifikacijos

ModelisSvoris
Medium35g
Hard40g

Specifikacijos

Geriausias naudojimas:
Touring
Rodyti visus

atsiliepimai   (10)

Patvirtintas pirkėjas
"Quick delivery from the US to Canada and exactly as ordered. Flawless shopping experience! My tip to install, use a fairly big set of those quick adjust pipe wrench that opens to 2” gap or so. Just press them into position and use them to get the old ones half way out. Easy peezy."
Flavelle Scott (Mount Currie) 21/01/27
Patvirtintas pirkėjas
"The Marker U springs arrived faster than expected, and are exactly as advertised."
Kenneth Linden (Irvine) 21/01/19
Patvirtintas pirkėjas
"Completely agree with Karol below. Nightmare to install. Had to file the inner edge a bit to get them on, after various failed attempts started to chew up the plastic/carbon body of the binding. The cut ends of the springs are pretty unrefined and could do with a bit of filing before they leave the factory. Once on, they work fine, I'm sure, and I got a swift and sensible reply from Skatepro when I asked for advice, so overall a positive experience. Would certainly use this retailer again."
Archie Gillies (Aberdeen) 20/11/12
Patvirtintas pirkėjas
"Have not had a chance to test them, not enough snow yet, but have no reason to believe they would not work. Got them to replace the "hard" DIN 12 bows that came with my bindings. They certainly were a bitch to install though. Not like the manufacturer describes it, just remove the small screw and slide it out/slide it in. The prongs are not quite parallel but rather convergent a bit. At the end I managed to spread them a little by forcing a suitable size of a socket wrench in between of them."
Karol S. (Northport) 19/10/28
Rodyti visus 10 atsiliepimus
SkatePro